MIMAKI UJF-3042HG Specifications download pdf (Page 60)

Setting the Head Height

3-8

Gap check

Select operation when obstacles are detected during drawing.

Press the key in the local mode.

Select the [HEAD HEIGHT] by pressing the or

key, and press the key.

Select the [GAP CHECK] by pressing the or

keys, and press the key.

Select the mode by pressing the or keys, and

press the key.

• Set value: ON, OFF

• When ON is selected:

Before drawing, the work height is checked with the specified table height (media thickness).

Before and during drawing, if the work sensor is shielded, the table is lowered until it is unshielded to

change the table height.

If the work sensor is shielded when the table is lowered to the bottom, a message of [WORK High]

appears and the operation stops.

• When OFF is selected:

Before drawing, the work height is checked with the specified table height (media thickness), and if the

work sensor is shielded, a message of [WORK High] appears and the operation stops.

Press the key several times to end the setting.

• The gap check function is not a function to avoid the head hit completely by detecting obstacles. Even

when the GAP CHECK is “ON”, be sure to check the work height visually before drawing.

<LOCAL>

FUNCTION

FUNCT I ON

WOR K S E T < E N T >

ENTER

HEAD HE I GHT

MEDIA THICKNESS<ent>

ENTER

HEAD HE I GHT

GAP CHECK : ON

ENTER

END

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 155 156

No comments

MIMAKI UJF-3042HG Specifications Page 60