Checking UV ink curing level
4-42
11
Press the key.
• Test drawing starts.
12
Check the drawing pattern after completion of the drawing.
• If the UV light intensity goes lower, good drawing pattern cannot be obtained. In this case
execute the operation of “Adjusting UV light level”.
Adjusting UV light level
1
Select the “UV LEVEL MODE” of the set up menu.
(1) Press the key in the local mode.
(2) Select the [SET UP] by pressing the or key, and press the key.
(3) Select the [UV LEVEL] by pressing the or key
(4) Press the key.
2
Select a light level by pressing the
or key.
• Set value : Strong, Weak, Standard, No, No Draw (Light intensity becomes stronger)
3
Press the key.
4
Press the key twice to finish.
5
Check UV curing again
• Set media and create the drawing pattern of the UV light intensity. ( P.4-41)
• If preparation of the UV irradiation device in procedure 9 has not been completed, or the
temperature of the water heating system has not reached the predetermined value, a
message is displayed. Drawing is not allowed in such cases. When the display is disappeared,
drawing can be started.
If the UV ink curing level is not changed by adjusting the UV light intensity, the UV lamp is
deteriorated.
• Check the UV lamp irradiation duration ( P.4-38)
• Check the UV lamp irradiation level ( P.4-44)
• Replacing the UV lamp. ( P.4-38)
** TEST DRAW **
ENTER
FUNCTION
ENTER
ENTER
SET UP
UV LEVEL : H I GH
SET UP
UV LEVEL <en t >
ENTER
END
Comments to this Manuals