MIMAKI JF-1631 Specifications download pdf (Page 13)

xii

For safe operation

WARNING

Power supply and voltage

• This unit contains parts applied high

voltage.Carrying out electrical work by

those unauthorized for that work is

prohibited.

• To prevent electrical shock, be sure to set

OFF the main power circuit breaker and

disconnect the power plug before carrying

out maintenance.For some units,

capacitors may take one minute for

discharging; therefore, start maintenance

work three minutes after setting OFF the

main power circuit breaker and

disconnecting the power plug.

• Be sure to carry out grounding work to

prevent electrical shock.

• Use the unit under the power specifications

given.Be sure to connect the power cable

plug to a convenient outlet grounded, or fire

or electric shock might occur.or it may

cause electrical shock.

• The main power circuit breaker should be

set ON only by personnel with sufficient

knowledge about operations of this unit.

• In rare cases, the UV lamp may break.We

recommend you to replace the UV lamp

with a new one before it reaches its rated

life.

• Before replacing, mounting or demounting

a lamp, be sure to set the power OFF,or it

may cause electrical shock.

• Never look at the UV lamp being lit with

your naked eyes,or it may cause pain in

your eyes or visual impairment.Be sure to

wear safety glasses.

• Do not apply ultraviolet (UV) light directly to

your skin,or it may cause irritation on your

skin.

• Be sure to use only the UV lamp

recommended by Mimaki,or it may cause

fire or damages to the unit.Never use UV

lamps other than those recommended by

Mimaki.We would take no responsibility for

any troubles caused through the use of a

UV lamp not recommended by Mimaki.

• Do not touch the lamp on or right after the

lamp off with bare hands to avoid from burn

injury.Make sure to replace the lamp after it

cools down completely.

Handling of UV lamp Laser sensor

• The UV lamp is made of glass and should

not be dropped, hit against anything, given

excessive force or scratched, or it may

cause damage to the UV lamp.

• Do not use the UV lamp in an ambience

with a possibility of catching fire (gasoline,

combustible gas spray, thinner, lacquer,

powder dust, etc.). In addition, do not put

paper or cloth near or on the UV lamp, or it

may cause fire.or it may cause electrical

shock.

• Do not break a used UV lamp; put it in a

container and discard likewise ordinary

fluorescent lamps according to the local

regulations.Breaking a UV lamp will cause

glass fragments to be scattered.

• A laser sensor (Class 2) is installed in this

unit. Never expose your naked eye to the

laser beam directly. That can cause an eye

pain or a vision abnormally.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 141 142

Comments to this Manuals

No comments