MIMAKI JF-1631 Specifications download pdf (Page 16)

xv

CAUTION

About cleaning About firing and smoking

• After using the unit long time, foreign

materials and dust may be gathered on the

conductive and insulating parts, causing

electric leakage.Periodically clean such

parts.

• For cleaning, do not use compressed air

because it scatters foreign materials and

dust, which may cause malfunctions when

put inside the conductive parts.Be sure to

use vacuum cleaner for cleaning of foreign

materials and dust.

• Do not use the unit in a place where there

is a possibility of being wet, or electrical

leakage may occur.

• Electrical leakage, if it should occur, may

lead to electrical shock of personnel or fire.

• In order to prevent accidents from

occurring, be sure to carry out periodic

inspections and replacement of time-

change components.

• Touching hot parts such as the UV lamp

with combustible materials may cause firing

and/or smoking.

Leaving combustible materials under the UV

lamp for a couple minutes may also cause firing

and/or smoking.

• After the unit is used long time, foreign

materials or dust gathered on the stabilizer

or other parts may cause electrical leakage

or insulation deterioration may cause firing

and/or smoking.Periodically clean the parts

and measure the insulation resistance,

replacing deteriorated parts, if any.

• After the unit is used long time, screws, etc.

on the conductive parts may be loosened,

causing firing and/or smoking.Periodically

tighten such screws.

• Because this unit is not of explosion proof

type,do not use it in an ambience with

hazardous materials, or a possibility of

explosion may arise.

• If abnormalities of the unit such as a

strange odor, a smoking or a spark burn

are found, turn the power off and call

Mimaki immediately.

Notes on UV lamp

• When handling the UV lamp or the silica

glass on the bottom of the irradiation

device, be sure to wear the gloves attached

and never touch them with bare hands, or

the UV ink curing level is significantly

lowered.If the UV lamp or silica glass is

contaminated,wipe it with clean gauze

moistened with alcohol.(Do not use alcohol

for cleaning the exteriorcover,or the paint

will peel off.)）

• Securely mount the UV lamp to the

socket,or the lamp may be dropped or

overheated.

• The UV lamp performance and service life

are significantly affected by the UV

irradiation and UV power supply units

used.Never use those UV devices other

than those recommended by Mimaki.We

would take no responsibility for any

troubles caused through the use of a UV

devices not recommended by Mimaki.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 141 142

Comments to this Manuals

No comments