MIMAKI JV3-160S Setup Guide download pdf (Page 59)

– 3.21 –

3-4-6. Stripes are always drawn at the time of scanning

Problems Black or white stripes are always drawn at the time of scanning.

Causes 1) The value of [MEDIA COMP.] is not correct.

When the media is changed, perform SETUP and [MEDIA COMP.]

to set values which suit the media.

2) A medium that is heavier than the specification is placed. (For the case

where black stripes appear)

3) Thicker media is used. However, the setting values for light-weight

medium remain.

4) The heater temperature setting is not appropriate.

Checking procedures 1) Execute SETUP - [MEDIA COMP.] to check that the value of [MEDIA

COMP.] is correct.

2) Medium weight measurement (medium of which weight is 25 kg or less

is recommended)

3) Check whether or not the distance compensation matches the medium

used.

4) Check that the set heater temperature is appropriate for the media.

Remedies 1) Same as Checking procedure 1).

Note that it may be necessary to specify a media correction value for

same host system. (See the table below)

2) Use a medium of which weight is 25 kg or less.

3) Set the correction value.

4) Set the heaters (pre-heater and print-heater) to appropriate values.

Priority setting Media correction value used

Panel Media correction value set by the user at the time of media correction.

Host Correction value specified by command.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 169 170

No comments

MIMAKI JV3-160S Setup Guide Page 59