MIMAKI JV3-160S Setup Guide download pdf (Page 84)

– 4.20 –

Printheater replacement procedure

1) Remove the black cable from the cable

clamp on the terminal board at the bottom

left of the H-platen assy.

2) Remove terminals B1 to B4 of the terminal

board.

3) Remove the cable from the cable clamp at

the bottom right of the H-platen assy.

4) Slightly pull the Thermistor cable of the

H-platen assy from the instrumentation

case, and then turn over the H-platen assy.

5) Remove the heater hold plate and the heater

joint hold plate.

6) Remove the wire heater P130/160 from the

slot.

7) After replacement, check the precaution

(page 4.21).

Preheater replacement procedure

• Do not remove the cap bolt.

Removing it prevents reassembling.

1) Remove the Y cover and the left cover.

2) Remove the blue cable from the cable

clamp.

3) Remove terminals B5 to B8 of the terminal

board.

4) Loosen the cap bolt on the front side of the

H-platen cover assy by about 2 mm.

5) Loosen the screw of the platen cover R

BKT at the back of the main unit.

6) While pulling out the H-platen cover assy,

remove the cable from the thermost

terminal at the back.

7) Being careful about the thermistor cord and

paper sensor assy at the center, remove the

H-platen cover assy.

8) Remove the R-heater hold plate and the R-

heater joint holdplate.

9) Remove the wire heater P130/160 from the

slot.

10) After replacement, check the precaution

(page 4.21).

Cable clamp

Cable clamp

Cable clamp

Thermostat

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 169 170

Comments to this Manuals

No comments