4-27
Cleaning of wiper and cap
4
Daily Maintenance
6
Remove ink stuck to the wiper and the bracket with the exclusive
cleaning swab soaked in the cleaning liquid.
• If stain or bent of the wiper is too severe, replace the wiper with new one.
Conduct replacing follow the wiper replacement procedure, after completing this
operation.
7
Remove the wiper M with tweezers.
8
Drip wiper M with several drops of
cleaning liquid and clean it with
nonwoven cloth.
• Avoid using the material that will leave dust or
fiber after use such as paper towel.
• When remarkable deformation or wear is seen on
the wiper M, replace it with the new one.
9
Check the inside of the suction nozzle
and clean them if they are dirty.
(1) Remove hardened ink or the attached dirt using a
stick with fine tip.
(1) Using the dropper, drip several drops of cleaning
liquid inside the suction nozzle and clean with
nonwoven cloth.
10
Check around the O ring under the
suction nozzle, and clean it if it is
stained.
• Around the O ring, uncured ink is sticking. Wipe it
out with nonwoven cloth.
11
Attach the wiper M to the suction
nozzle.
• Adjust the wiper M and the suction nozzle so that
they are on the same height.
Wiper M
Wiper M
Comments to this Manuals